cadquery/monitor
Roberto Alsina c2caea9039 Large design change.
While not as pretty this should work much better mechanically
based on the results from the last test print.

* Added room for the plugs to slide from the middle outwards
* Made back reinforcement much larger so it connects the piece that is
  split by that plug channel
* Removed separate board cutout (not needed anymore)
* Fix cable channel (was cutting through end caps)
* Change shelling parameters so it keeps a cap on both ends
* Adjusted segment breaks for new reality

* TODO: adjust rear hinge design to be flat and not "envolving"
2022-07-24 11:11:16 -03:00
..
case.py Large design change. 2022-07-24 11:11:16 -03:00
hinge.py tweaks 2022-07-23 16:12:56 -03:00
lower_arm.py tweaks 2022-07-23 16:12:56 -03:00
parameters.py Large design change. 2022-07-24 11:11:16 -03:00
README.md cleanup 2022-07-22 09:51:31 -03:00
rear_mount.py tweaks 2022-07-23 16:12:56 -03:00
upper_arm.py tweaks 2022-07-23 16:12:56 -03:00

A monitor case for my funky 1920x480 thing. It's going to connect to a microphone tripod I have around.

It's quite parametrized so it should adapt to similar and smaller things (modulo the break-into-smaller-parts process)